Jump to content

Error Applying Image

Recommended Posts

I was in the middle of a mass imaging session. Over 100 laptops. Everything went fine, until i came to one model. It started throwing a "Error applying Image" message and would not finish.

I attempted to rebuild the image, but that too yields the same result. I am not mapping to S: or T: and I have the correct driver pack. Anything else I should look into?

Link to comment
Share on other sites


Please navigate to X:\Windows\Debug\Deploy.log and send that to us at support@smartdeploy.com. After we view this log we may ask for additional information. This could be caused by storage controller driver being different than that in the platform pack. But we will have to take a look at the log. The support email will almost always the fastest way to resolve issues found.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...