boomerman

Is the answer still to this issue is I have to build all new images if I want to use 1809?

What I do it disable the non SSD drive in the bios, image the pc then re-enable it in the bios after the pc has booted to the desktop for the first time.

I have tried to image 2 different computers this morning, 1 Dell and 1 Lenovo Thinkpad and both are getting the following error when it located the platform packs.

Unable to open the Platform pack. The platform pack may be corrupt.

I deleted the the platform packs and downloaded them again still getting the issue.

I am on version 2.0.3005

When applying a windows 7 image to a HP laptop 450 G2  i get the unable to inject necessary drivers error right before the image is done.

I have enclosed the logs I pulled from the laptop.

Deploy.log

Windows Defender is not running on the pc. 

I have a windows 10 ( Creator edition 1709)  image that is 35 gigs that takes about 80 minutes  to capture once it starts the capture phase.

I have another windows 10 image ( Creator edition 1709) that is 40 gigs that only takes 45 mins at the most.

I have cleaned up the image as much as possible by removing temp files, pagesys files and restore points.

My host pc is 8 gigs of ram running windows 10. It runs nothing else but SmartDeploy and my virtual images

I am on version 2.0.2097 of SmartDeploy.

Any ideas why this one is taking so long?

I am using the latest version 2.0.2010 and I have re-captured and re-created the boot media via the Media Wizard, still the same issue.

I will email support. 

Thank you.

I am working with a HP ZBook 15 U G3 that once I image the laptop and it reboots for the first time to continue the setup that is when it will blue screen,then it reboots again and my 2 choices are load Windows normally or start Windows repair.

Neither option works.

Any ideas?